The ring of fire region is best known for which of the following characteristics?

  • Volcanoes and fumaroles (holes in the earth where volcanic gases are released)
  • Hot springs
  • Geysers

Most geothermal resources are near the boundaries of the earth’s tectonic plates

The most active geothermal resources are usually found along major tectonic plate boundaries where most volcanoes are located. One of the most active geothermal areas in the world is called the Ring of Fire, which encircles the Pacific Ocean.

When magma comes near the earth's surface, it heats ground water trapped in porous rock or water running along fractured rock surfaces and faults. Hydrothermal features have two common ingredients: water (hydro) and heat (thermal).

Geologists use various methods to find geothermal reservoirs. Drilling a well and testing the temperature deep underground is the most reliable method for locating a geothermal reservoir.

U.S. geothermal power plants are located in the West

Most of the geothermal power plants in the United States are in western states and Hawaii, where geothermal energy resources are close to the earth's surface. California generates the most electricity from geothermal energy. The Geysers dry steam reservoir in Northern California is the largest known dry steam field in the world and has been producing electricity since 1960.

Last reviewed: February 15, 2022

The area in the basin of the Pacific Ocean that hosts more than 40 percent of geothermal energy resources is called the ring of fire. It is a volcanic belt where a large number of earthquakes and volcanic eruptions have been witnesses. It is also called ‘Circum-Pacific Belt.’ The topic, ‘Ring of Fire’ is important for the upcoming UPSC Prelims as recent news of the discovery of a ring of fire on the surface of the planet Venus made highlights. Hence, aspirants should know what the circum-pacific belt is and what is the ring of fire discovered on Venus.

As a ring of fire is a volcanic belt, aspirants are suggested to read the basics of volcanoes, earthquakes, and volcanic landforms from the articles linked in the table below:

Important Facts about Ring of Fire for UPSC

The table below mentions some important facts about the ring of fire:

Ring of Fire – Facts for UPSC

What is a ring of fire? The path located at the rim of the pacific ocean, which is characterized by active volcanoes and earthquakes is called the ring of fire.

It is also called the Circum-Pacific Belt or Circum-Pacific Seismic Belt.

Why is it called the ring of fire? It is so-called because it marks a track around the rim of the pacific ocean. Also, since more than 75 percent of earth’s volcanoes and 90 percent of earthquakes are witnessed here, it is called the ring of fire. 

Note: It is not a clear circular ring. A horseshoe-like shape is formed with the ring of fire. 

What is the length of the circum-pacific belt? The ring of fire is 40000 km long. 
What are the countries/Cities located in the ring of fire? Bolivia, Chile, Ecuador, Peru, Costa Rica, Guatemala, Mexico, United States, Canada, Russia, Japan, Philippines, Indonesia, New Zealand, and Antarctica are some of the important places located in the ring of the fire. 
What are the features of the ring of fire? 1. The ring of fire features the following:
  • Oceanic trenches
  • Volcanic arcs, and
  • Volcanic belts and/or plate movements

2. It is home to around 452 volcanoes (active and dormant volcanoes both)

3. More than 80 percent of the world’s largest earthquakes occur along the circum-pacific belt.

4. It is the most seismically active region followed by Alpide Belt that extends from Java to the northern Atlantic Ocean via the Himalayas & Southern Europe

Candidates planning to appear for the Civil Services Exam can visit the link UPSC Syllabus for complete information on the subjects covered in the examination.

Ring of Fire and Plate Tectonics

As the ring of fire is caused by the plate tectonics, it is important to know a few facts about it:

  1. Convergent Plate Boundary – When two tectonic plates collide into each other, a plate boundary is formed, which is called a convergent plate boundary. These boundaries are subduction zones where a heavier plate subducts under the lighter one. When the subduction takes place, there is a transformation of dense magma into buoyant magma that rises up the earth’s surface. Read about the Types of Magma and Lava on the given link. This rising magma gives rise to active volcanoes. Example:
    • Pacific Plate and North American Plate converge where pacific plate subducts under North Americal plate – This convergent plate boundary continues to form Aleutian islands (Hosts  27 Active Volcanoes)and Aleutian Trench.
    • Nazca Plate and South American Plate converge where Nazca plate subducts beneath the South American tectonic plate. This convergence created Andes Mountain and Peru-Chile trench. Nevados Ojos del Salado which is the world’s highest active volcano
  2. Divergent Plate Boundary – When two tectonic plates pull apart from each other, the seafloor starts spreading. The boundary thus created is called a divergent plate boundary as a result of seafloor spreading, the magma wells up. The hot magma gets cooled down by cold seawater. This continuous process of magma welling up and it getting cooled down by the seawater creates high ridges on the ocean floor over millions of years.  Example:
    • In the ring of fire, East Pacific Rise (located on the divergent boundary of the Pacific Plate and the Cocos Plate) is a site of major seafloor spreading site.
  3. Transform Plate Boundary – When two tectonic plates slide horizontally past each other, stress is built over the areas where these two plates touch while passing. The stress keeps building during the time the plates keep sliding past each other. This stress creates fault in rocks and later become the cause of earthquakes. The transform boundaries in the ring of fire have the majority of earth’s faults. Example:
    • One of the most active faults in the ring of fire is San Andreas Fault (North American’s West Coast)

Additionally, candidates can find relevant links below to boost their preparation for the upcoming UPSC examination –

Ring of Fire – The list of active volcanoes

To be noted is that the western edge of the ring of fire has most of the active volcanoes.  Some of the active volcanoes are:

  1. Mount Ruapehu in New Zealand
  2. Krakatau Island Volcano in Indonesia
  3. Mount Fuji of Japan
  4. The Aleutian Islands
  5. Mount St. Helens
  6. Popocatépetl

What is the Ring of Fire that is found on Plant Venus?

NASA’ Magellan Mission captured high-resolution images of the Venus surface were recently observed by planetary researchers. Those images led to the discovery of unusual circular structures called coronae. Using computer simulations, to classify the current activity of corona structures, the scientist found the ring of fire on the Venus planet. The coronae structures have been classified by the scientists into two groups:

  1. Coronae that have formed above an active plume that is currently rising and carrying molten material, and
  2. Coronae are above a plume that has cooled and becomes inactive.

Scientists have defined Venus’ ring of fire as the band of coronae overlying active mantle plumes forming a belt in Venus’ southern hemisphere.

A few links on relevant mission by NASA to help you do comprehensive preparation of the exam –

Conclusion

The topic, ‘Ring of Fire’ is important from the context of the Geography subject of the IAS Exam. For the preparation of geography, which is a part of prelims and mains GS-1, you can check the articles linked below:

Ring of Frei – UPSC Notes:-Download PDF Here

UPSC Preparation-Related Links:

Which of the following countries have territorial claims in Kashmir?

The region is divided amongst three countries in a territorial dispute: Pakistan controls the northwest portion (Northern Areas and Kashmir), India controls the central and southern portion (Jammu and Kashmir) and Ladakh, and the People's Republic of China controls the northeastern portion (Aksai Chin and the Trans- ...

Which of the following rulers was most responsible for ending the persecution of Christians in ancient Rome?

In 313 C.E., Roman emperor Constantine the Great ended all persecution and declared toleration for Christianity. Later that century, Christianity became the official state religion of the Empire.

In which of the following regions is Islam the predominant religion praxis?

Islam is the dominant religion in the Middle East, which is comprised of the regions of North Africa and Southwest Asia.

What is a characteristic of Turkey's largest city?

Istanbul which was home to many civilizations for many centuries is Turkey's most populous city. One of most important characteristics of Istanbul is the fact that it has received migration at every era of the history. Istanbul continued receive migration during the Republican Period, too.